Getting Started
Before you get started with installations, make sure you know your device by checking out the Inspectron Tools website. The process for connecting any Inspectron camera device with smart glasses is consistent. Simply follow the steps below.
Configuration and set up
To connect the borescope camera with the right network:
- Turn on the Inspectron device and wait for the Connection mode Led Indicator to turn blue or green.
- You can press Brightness Controls for Flashlight, which is located on top of the device to change the Wifi status. Blue means router mode and green means P2P mode.
- After the device is on, sign in to the Frontline Workplace App on your smart glasses.
- Go to Settings > Connect Devices > Connect Inspectron Device.
5. Select Continue to have the list of available devices displayed.
Note: Make sure that the Inspectron device is in range of the smart glasses.
6. Select the correct device.
Note: On selecting the device, you need to be ready with the Wifi QR code. Both the Inspectron device and the smartglasses need to be connected to the same wifi.
7. Point the inbuilt camera of the smart glasses towards the Wifi QR code.
⇒ The borescope camera is connected and you are notified with a success message.
Inspectron Camera as default for xAssist Calls
From now on, when the borescope camera is connected successfully, it will be the default camera for xAssist calls.
You can switch the flashlight on/off if the borescope camera has one. Depending on the model of the Inspectron Camera and its features, you could use various features of the camera by using the controls on the device.
You can take pictures with the borescope camera. Important to add, that since the aim of the device is to capture clear pictures in narrow parts and areas, make sure that the device is very close to the place you want to focus on.
Disconnecting the Inspectron device
To disconnect the camera and go back to using the inbuilt camera of your smart glasses, simply turn off the Inspectron Device.